POOL COVER INSTALLATION – HOW TO

Leave this to the experts

You can install your own Daisy pool cover and roller yourself using our installation sheets and videos, or even easier, use one of our Daisy Experts.

Pool Cover Installation

Pool Cover Installation

 

 

 

To install your solar pool cover:

  1. Lay the pool cover, bubble side to the water
  2. Flatten out all air bubbles so that the cover sits flat on the water
  3. Using your pool as a template, take a pair of ordinary household scissors (the sharper the better) and with someone holding pool cover in position, cut the edge of the cover so that it sits flat on the water with about 50 – 75mm rising up the side of the pool (but not necessarily to the top edge of the pool).

If required, you can:
A) Cut the pool cover back to waterline, however, wait 2-3 weeks after initial cut for it to settle down.
The pool cover can shrink in the length in the first couple of weeks, so don’t make the initial cut too short.
B) Cut two vertical slits in the cover upturn, either side of your skimmer box, fold the flap you have created into the skimmer box, therefore allowing you to hose debris off the top of the cover into the skimmer box.

Installation Sheets and Videos: Visit our resource centre to download our step by step installation sheets and watch our how to install your Daisy pool cover. We’ll step through the installation of all our covers and more!

Any questions? Visit our resource centre and check out our FAQs. There’s lots of help there!

Need assistance? Contact your Daisy Expert located in most states of Australia, we can help you install your Daisy Pool Cover and Roller or provide advice.